# Generated for:
<br /># Alchemy
<br /># 
<br /># unsolclic version: v3.7
<br /># open a telnet/ssh session on your device and run the script below.
<br /># Note: Use Status/Wireless survey to verify that you have the
<br /># antenna plugged in the right connector. The right antena is probably
<br /># the one which is at the right, looking the WRT54G from the front
<br /># (where it have the leds). If needed, change the antenna connector
<br /># at Wireless->Advanced Settings.
<br /># Security notes:
<br /># Once this script is executes, the router password for root/admin users is "guifi"
<br /># You must change this password if you want to keep it secret. If you like to still
<br /># be managed externally, you must install a trusted ssh key. Upon request, your setup
<br /># might be asked for being inspected to check the Wireless Commons compliance.
<br /># No firewall rules are allowed in the public network area.
<br /># By being in client mode, the router has the firewall enabled to distinguish between
<br /># private and public areas, and only SNMP, ssh and https 8080 ports are enabled
<br /># for external administration. Everything else is closed, therefore you might
<br /># have to open ports to share resources.
<br /># 
<br /># TorelloGestiomat
<br /># Global network parameters
<br />nvram set router_name="TorelloGestiomat"
<br />nvram set wan_hostname="TorelloGestiomat"
<br />nvram set lan_ipaddr="10.138.50.193"
<br />nvram set lan_gateway="0.0.0.0"
<br />nvram set lan_netmask="255.255.255.224"
<br />nvram set wan_proto="disabled"
<br />nvram set lan_domain="guifi.net"
<br />nvram set wan_domain="guifi.net"
<br />nvram set http_passwd="guifi"
<br />nvram set time_zone="+01 2 2"
<br />nvram set sv_localdns="10.138.50.194"
<br />nvram set wan_dns="10.138.50.194 10.138.0.2 10.138.50.194"
<br />nvram set wl_net_mode="b-only"
<br />nvram set wl0_net_mode="b-only"
<br />nvram set wl_afterburner="on"
<br />nvram set wl_frameburst="on"
<br />nvram set txpwr="28"
<br />nvram set txant="0"
<br />nvram set wl0_antdiv="0"
<br />nvram set wl_antdiv="0"
<br />nvram set block_wan="0"
<br /># 
<br /># Management
<br />nvram set telnetd_enable="1"
<br />nvram set sshd_enable="1"
<br />nvram set sshd_passwd_auth="1"
<br />nvram set remote_management="1"
<br />nvram set remote_mgt_https="1"
<br />nvram set snmpd_enable="1"
<br />nvram set snmpd_sysname="guifi.net"
<br />nvram set snmpd_syscontact="guifi_at_guifi.net"
<br />nvram set boot_wait="on"
<br /># This is just a fake key. You must install a trusted key if you like to have you router managed externally
<br />nvram set sshd_authorized_keys="
<br />ssh-rsa AAAAB3NzaC1yc2EAAAABIwAAAIEAwWNX4942fQExw4Hph2M/sxOAWVE9PB1I4JnNyhoWuF9v\
<br />id0XcU34kwWqBBlI+LjDErCQyaR4ysFgDX61V4kUuCKwBOMp+UGxhL648VTv5Qji/YwvIzt7nguUOZ5A\
<br />GPISqsC0717hc0Aja1mvHkQqg9aXKznmszmyKZGhcm2+SU8= root@bandoler.guifi.net\
<br />"
<br />nvram set http_enable="1"
<br />nvram set https_enable="1"
<br /># 
<br /># NTP Network time protocol
<br />nvram set ntp_enable="1"
<br />nvram set ntp_server="10.138.0.2"
<br /># 
<br /># AP mode
<br />nvram set wl_mode="ap"
<br />nvram set wl0_mode="ap"
<br />nvram set wl_channel="10"
<br />nvram set wl_ssid="guifi.net-TorelloGestiomat"
<br />nvram set wl_macmode="disable"
<br />nvram set wl0_macmode="disable"
<br />nvram set wl_macmode1="disable"
<br />nvram set wl0_macmode1="disable"
<br /># 
<br /># Firewall disabled
<br />nvram set filter="off"
<br />#  Alchemy OSPF routing
<br />nvram set dr_setting="3"
<br />nvram set dr_lan_rx="1 2"
<br />nvram set dr_lan_tx="1 2"
<br />nvram set dr_wan_rx="1 2"
<br />nvram set dr_wan_tx="1 2"
<br />nvram set wk_mode="ospf"
<br />nvram set route_default="1"
<br />nvram set expert_mode="1"
<br />nvram set ospfd_conf="
<br />    !
<br />    password guifi
<br />    enable password guifi
<br />    !
<br />    interface br0
<br />    interface wds0.
<br />    !
<br />    router ospf
<br />     ospf router-id 10.138.50.193
<br />      network 10.138.50.192/27 area 0
<br />     default-information originate
<br />    !
<br />    line vty
<br />    !"
<br /># 
<br /># DHCP
<br />nvram set dhcpd_statics="
<br />    10.138.50.195 FF:FF:FF:FF:FF:FF TorelloDPlanasRadio1
<br />    10.138.50.196 00:1D:73:55:56:6F TorelloEsterRRd1
<br />    10.138.50.197 00:0D:0B:CB:55:0E TorelloCanReig4
<br />    10.138.50.198 00:16:01:F4:AF:04 TorelloAClavijoRadio1
<br />    10.138.50.199 00:12:F0:05:A5:2C TorelloPCasasTRadio1
<br />    10.138.50.200 00:16:01:AD:D5:AC TorelloDabkiewiczRadio1
<br />    10.138.50.201 00:00:00:00:00:01 TorelloillamolaRd2
<br />    10.138.50.202 00:1D:73:18:1A:87 sergimariaRd1
<br />    10.138.50.203 FF:FF:FF:FF:FF:FF TorelloMiquel
<br />    10.138.50.204 FF:FF:FF:FF:FF:FF JBonetRadio1
<br />    10.138.50.206 FF:FF:FF:FF:FF:FF TorelloMinaireRadio1
<br />    10.138.50.207 FF:FF:FF:FF:FF:FF TorelloCodisaRadio1
<br />    10.138.50.208 00:14:BF:D2:66:35 TorelloRTornerRd1
<br />    10.138.50.210 00:1D:73:55:73:57 TorelloSandraSanchezRd1
<br />    10.138.50.211 00:15:6D:AD:5E:BC TorelloJorditejedorRd1
<br />    10.138.50.212 00:21:29:B5:E6:DA TorStMiquel34Rd1
<br />    10.138.50.213 00:1D:7E:C6:D2:32 TorelloIsmaRd1
<br />    10.138.50.214 00:15:6D:AE:D9:2D torelloaserraRd1
<br />    10.138.50.216 00:16:B6:C9:17:E8 TFrancescXRd1
<br />    10.138.50.217 00:15:6D:D9:16:F8 TorelloJuanRRd1
<br />    10.138.50.218 00:15:6D:F7:78:55 TorelloDRubioRd1
<br />    10.138.50.221 00:15:6D:F6:74:7B TorelloViveRd1
<br />    10.138.50.222 00:18:39:83:0E:70 TorelloRosellRd2"
<br />nvram set dhcp_start="227"
<br /># 
<br /># 
<br />nvram set rc_startup="#!/bin/ash
<br /># 
<br />#  unsolclic: v3.7
<br />#  radio:     878-TorelloGestiomat
<br /># 
<br /># 
<br />    /bin/sleep 10
<br />    /usr/sbin/wl shortslot_override 0"
<br /># 
<br /># end of script and reboot
<br />    nvram commit
<br />    reboot
<br />